Case Study Of XanthRemover
Instructions
Only use this product after you have read and understood the patch test instructions below. This product contains high percentage of glycolic acid and it is meant to burn benign skin lesions and be used for deep skin peels hence you must follow the mandatory patch tests before use. This product is a very effective tool and as such must be used appropriately. Do not attempt to use it before completing the full patch testing as described in detail in the instructions below. Please note that the patch testing procedure lasts for several days and must be observed and completed precisely as described.
Please note that incorrect use or incorrect aftercare use can lead to:
Unnecessary swelling (temporary), discomfort and pain
Scarring, Hypo and /or hyperpigemntation, Infection and/or delayed healing if the inappropriate aftercare is used, Unexpected downtime, distress due to unexpected downtime.
Mandatory Patch Tests.
The patch test is required and mandatory for you to to learn the effects of the XanthRemover on your skin and seborrheic keratosis before you use it. I
Day one: Apply a tiny amount of gel below the chin area and on the forearm, the area to be covered should not exceed 0.5 cm square (small area). Keep the gel for 3 minutes at most. Wipe off using a clean makeup cotton pad and rinse with water. If the treated part presents redness and itching for longer than 24 hours, avoid the use of the product.
Day two: Apply a tiny amount of gel somewhere else below the chin area and forearm, the area to be covered should not exceed 0.5 cm square (small area). Keep the gel for 10 minutes at most. Wipe off and rinse with water.
Day three: Apply a tiny amount of gel somewhere else below the chin area and forearm, the area to be covered should not exceed 0.5 cm square (small area). Keep the gel for 15 minutes at most. Wipe off and rinse with water.
This patch tests will serve to make sure you do not have any adverse reaction to the gel. Also, you will learn how to use the product by observing the peeling effects after a short duration of the application.
Day five: Apply tiny amount of gel on one seborrheic keratosis. Keep the gel for 60 seconds at most. Wipe off and rinse with water. Make sure the gel does not get in contact with the eyes.
Day six: Apply tiny amount of gel on another seborrheic keratosis. Keep the gel for 5 minutes at most. Wipe off and rinse with water. Make sure the gel does not get in contact with the eyes.
Day seven: Apply tiny amount of gel on another seborrheic keratosis. Keep the gel for 10 minutes at most. Wipe off and rinse with water. Make sure the gel does not get in contact with the eyes.
Observe the peeling effects on the seborrheic keratosis treated with the cosmetic peel over the next three days. If you notice any undesired effect stop using the product.
Day eleven: You should have learned that the longer you keep the gel on, stronger and deeper the peeling effects of the product. Apply the gel on a fourth untreated seborrheic keratosis and keep the gel on for 20 minutes, no longer. Wipe off and rinse with water. Make sure the gel does not get in contact with the eyes. In case you have only one or two seborrheic keratosis wait a minimum of one week (not one day) between each patch test application on the same seborrheic keratosis.
The above patch tests will serve for you to get used to the way the Gel works on your skin. You should have learned that the longer you keep the gel on the more the peeling effects of the product on your seborrheic keratosis. In the unlikely event of an adverse reaction of the gel stop using it.
Modality of Application
There is no maximum length of application this is established by you, the more quickly you want to get rid of your Seborrheic Keratosis the longer you will have to apply the product on your seborrheic keratosis. The length of application can be 30 minutes, 1 hour,2 hour and even longer you decide what is it. Please bear in mind that the length of application is strictly decided by you it can be whatever you want but the longer you keep the product on the deeper the burn. so be careful.
In the unlikely case no scabbing/peeling of your seborrheic refer to the pre application degreasing process outlined in the main introduction. Alternatively contact us using whatsapp.
- Wash your hands.
- Cleanse and dry thoroughly the area where the product will be applied.
- Apply it on your seborrheic Keratosis
- WARNING avoid contact with the eyes. Keep the product out of the reach of children. Do not eat. The product is meant for topical use only on intact skin.
- Wipe off using a clean make-up cotton pad and rinse with warm water for the maximum specified period only after having completed the patch test procedure outlined.
Two to three days after the application you should notice some scabbing taking place on your seborrheic Keratosis. What to do is on the 3rd or 4th day if the scabbing has taken place, scratch gently the keratosis with your CLEAN finger-nail and see if it peels off. If not try again a day or two days after.
In case no peeling or scabbing of the seborrheic keratosis apply the Xanthremover gain on the same seborrheic keratosis but increase the length of application.
Allow a minimum of 2 weeks intervals between applications on the same seborrheic keratosis. In the unlikely event, the scabbing/peeling process is still ongoing after the 2 weeks interval wait until the area has returned to normal before reapplying. DO NOT USE makeup ON THE AREA YOU HAVE USED THE PRODUCT UNTIL THE PEELING EFFECT IS OVER.
You should be patient in the removal of your seborrheic keratosis.
In most cases, the seborrheic keratosis are removed within 4 sessions, but it could take more applications.
The longer you keep the Product on the seborrheic keratosis during each application the more the peeling effects. As a consequence the longer you keep your formulation on your seborrheic keratosis the less applications are needed to achieve satisfactory results. Some of our customers have been able to achieve the desired results in 1 to 2 sessions just by keeping the gel on for over 1 hour per application.
Conversely, the less you keep it on the seborrheic keratosis the more applications you will require in order to remove them.
Remember, if something seems not to be working get in touch with us using WhatsApp!
Do not engage in dangerous or strenuous activities and do NOT WEAR ANY TYPE OF MAKE-UP during the peeling or scabbing process as this could jeopardize the healing process, increase the chances of infections and therefore increase the risk of unnecessary complications including permanent scarring. Apply total sun protection/sunscreen after the peeling has taken place up until three months after you stopped applying the gel and you achieved the desired results. You must avoid any direct sun exposure for at least three months after the application of the gel. Failure to do so can lead to hyper-pigmentation as well as hypo-pigmentation.
Scars tissues may result due to the removal of your seborrheic keratosis even by using cosmetic peels.
What to do in case the peeling effects are not strong enough in my case? For Example I cannot manage to remove a mole, I cannot get enough deep peeling effects etc?
The XanthRemover has high concentration of Glycolic Acid and hence it is very strong per se. However in some circumstances the user would like to get very strong burning or peeling effects especially when removing benign moles or perform very deep skin peels.
1) The first course of action is increase the length of application. The longer the Product is kept on the skin, mole, Brown spot etc the deeper the burning or peeling effects.
2) If just keeping the Xanthremover gel on for longer does not cut it, then you can increase the effects of the XanthRemover by de-greasing the skin before applying the XanthRemover. The natural way of doing it is applying vinegar on the skin before the use of the XanthRemover. First you have to wash the skin thoroughly, then you dry it, and last using a cotton pad dipped into vinegar rub the skin a number of times with the cotton pad and vinegar. Dry the skin and apply the XanthRemover immediately after. This will enhance the effects of the XanthRemover.
3) If the use of vinegar is not enough for you the next step is Deep de-greasing using acetone. Wash the part of the skin you want to apply the XanthRemover on and once you dry it apply acetone rubbing it using a cotton cloth. Rub the area of the skin a number of times and then apply the XanthRemover once the skin is dry from the Acetone. Please be careful because the effects the XanthRemover will be very different from before. The burns and peeling effects will be much deeper